Description

The PYNQ-Z1 board is designed to be used with PYNQ, a new open-source framework that enables embedded programmers to exploit the capabilities of Xilinx Zynq All Programmable SoCs (APSoCs) without having to design programmable logic circuits. Instead, the APSoC is programmed using Python and the code is developed and tested directly on the PYNQ-Z1. The programmable logic circuits are imported as hardware libraries and programmed through their APIs in essentially the same way that the software libraries are imported and programmed.

Features:

  • ZYNQ XC7Z020-1CLG400C:
    650MHz dual-core Cortex-A9 processor
    DDR3 memory controller with 8 DMA channels and 4 high performance AXI3 slave ports
    High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
    Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
    Programmable from JTAG, Quad-SPI flash, and microSD card
    Artix-7 family programmable logic
    13,300 logic slices, each with four 6-input LUTs and 8 flip-flops
    630 KB of fast block RAM
    4 clock management tiles, each with a phase-locked loop (PLL) and mixed-mode clock manager (MMCM)
    220 DSP slices
    On-chip analog-to-digital converter (XADC)
    Memory:
    512MB DDR3 with 16-bit bus @ 1050Mbps
    16MB Quad-SPI Flash with factory programmed globally unique identifier (48-bit EUI-48/64™ compatible).
    MicroSD slot
    Power:
    Powered from USB or any 7V-15V source (see recommended products)
    USB and Ethernet:
    USB-JTAG Programming circuitry
    USB-UART bridge
    USB OTG PHY (supports host only)
    Gigabit Ethernet PHY
    Audio and Video:
    Electret microphone with pulse density modulated (PDM) output
    3.5mm mono audio output jack, pulse-width modulated (PWM) format
    HDMI sink port (input)
    HDMI source port (output)
    Switches, push-buttons, and LEDs:
    4 push-buttons
    2 slide switches
    4 LEDs
    2 RGB LEDs
    Expansion Connectors:
    Two standard Pmod ports
    16 Total FPGA I/O
    Arduino/chipKIT Shield connector
    49 Total FPGA I/O
    6 Single-ended 0-3.3V Analog inputs to XADC
    4 Differential 0-1.0V Analog inputs to XADC

Contact Us For More Details